meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
en:design_guide_polygon [2022/05/03 06:50] JSCAD Editor |
en:design_guide_polygon [2022/05/03 06:53] (current) JSCAD Editor |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| //NOTE: The ordering of points is VERY IMPORTANT. If the polygon is going to be extruded then the points must be in counter-clockwise order, otherwise the faces of the object will be facing inwards. See [[en: | //NOTE: The ordering of points is VERY IMPORTANT. If the polygon is going to be extruded then the points must be in counter-clockwise order, otherwise the faces of the object will be facing inwards. See [[en: | ||
| + | |||
| + | //HINT: Polygons should have a positive area.// | ||
| The following show examples of creating polygons from a list of points. | The following show examples of creating polygons from a list of points. | ||